It doesn’t take much to spread small particles (like sand) around. I used a new applicator and new rags for each window. Tapping helps you control the clean edge. When it comes to any kind of car detailing, edges are critical as the lines are where people’s eyes naturally travel. This way I don’t have to worry about keeping the edges clean. So I tape off the windows just as if I were going to paint them. I don’t like how the edges of my soft top fabric look after I get wax or the Meguaris product on them. After the dirt and grime are gone, I then let everything dry and move to the next step, tape. However, I tend to find that the condensation which builds up on the inside is the culprit for most of the clouded look. I don’t want to pick up something that might scratch them worse than they are. I always make sure that I am extra gentle when it comes to cleaning the plastic windows on my Jeep. I used Dawn dish soap as it does a good job of taking the road grease and kids fingerprints off of the plastic. Cleaning the PlasticĪfter I have purchased the and gotten my windows out, the next step is to make sure the surface was clean. I kinda prefer the windows attached for the outside treatment, but I figured I had them out already, just to keep going. I don’t think this is a critical step however, the fact I could get to all the window (at least for the inside) was a benefit for taking the windows off. Removing the windows allowed my to work more comfortably. In my case only the side windows come off of my soft top model. ![]() If you can remove the side and back windows for the restoration project, I would.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |